3D Printing Settings
0.16 layer height for nicer threads but 0.2 should work for a well set up printer (good part cooling)
Supports = None
Brim = None
Infill any from 15-100%
Never worry again about loosing your mowers gas cap.
This cap was modeled from my Victa lawn mower with a Briggs and Stratton 450E engine.
This is a vented, spill resistant cap similar design to the original.
Printed in PLA for pictures but recommend fuel safe PETG.
Larger model file for nicer curves.
ALL FREE ITEMS are licensed under Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International. To view a copy of this license, visit https://creativecommons.org/licenses/by-nc-nd/4.0/
ALL PAID ITEMS are licensed under Creative Commons Attribution-NoDerivatives 4.0 International. To view a copy of this license, visit https://creativecommons.org/licenses/by-nd/4.0/
Never worry again about loosing your mowers gas cap.
This cap was modeled from my Victa lawn mower with a Briggs and Stratton 450E engine.
This is a vented, spill resistant cap similar design to the original.
Printed in PLA for pictures but recommend fuel safe PETG.
Larger model file for nicer curves.
ALL FREE ITEMS are licensed under Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International. To view a copy of this license, visit https://creativecommons.org/licenses/by-nc-nd/4.0/
ALL PAID ITEMS are licensed under Creative Commons Attribution-NoDerivatives 4.0 International. To view a copy of this license, visit https://creativecommons.org/licenses/by-nd/4.0/
0.16 layer height for nicer threads but 0.2 should work for a well set up printer (good part cooling)
Supports = None
Brim = None
Infill any from 15-100%